News and Helpful Videos

Models WJT/RPJT/WJL/RPJL are very small and have a low silhouette format helps out in space to put these valves. The valves are used to prohibit the maximum pressure that can be a usable portion of the hydraulic circuit that is connected. They have a differential poppet reliefs, Model WJ will let pressure settings go up to 3000 PSI, pilot operated reliefs. Model RP will let pressure go up to 5000 PSI. It is an adjustable valve that can be reset and has a jamnut to lock the new settings. A shim set valve is left unaltered after it is installed...

On the inlet side of the HD2 pumps is induced to diminish noise, avoid cavitation, provide a flow of cooling oil and produce a standard of inlet filtration to give long life. They have alot of gear pumps that you can put on as charge pumps or add to a tandem or triple pumping division where the flow will help out other circuits. The take off power can go up 84 hp at 3000 rpm. You can get a high choice that will let the pump to be put in the tandem. The pumps and motors have the same fixed...

You should always test your pump before installing it. Here are a few examples of what you need to do. This is scoring the cartridge Withdrawal of the Inlet Support Plate Withdrawal of the Inlet Flex Side Plate Step one of the Outlet Support Plate Withdrawal Step two of Outlet Support Pate Withdrawal Withdrawal of the Outlet Side Plate Consecutive Withdrawal of Vanes from the Rotor. Beginning at the arrow at the Rotor Put together the Flex Side Plates over the Seal Packs while putting them over onto the InletOutlet Support Plates The Outlet Support Plate& Flex Side Plate added...

The plates that are for the inlet and outlet are the same. when pressure is provided behind each side plate that goes into the kidney shape piece, it is sealed by a distinct seal pack. Pressure builds up in the outlet and it also does in the cavities. The pressure cavities holds the plates in balance next to the rotor and give clearance for minimum internal leakage and friction. The plates also give movement for supplying under vane pressure to the space between the vane and insert. The bronze faces of the flex plates seat up against the rotor and...

These are a piston pump series that was made with construction machinery in mind. Here are the K3V Specs for different sizes K3V Dimensions K3V Mounting Direction & Drain Pump The mount on the pump that has the shaft pointed horizontally. The drain line need to be put above the top of the pump case it gets to the tank. The upper drain port needs to be used and the drain pipe size needs to be about the same or bigger than the drain port size so that the drain pressure in the casing don’t go past .02mp   K3V...