News and Helpful Videos

These pumps are very reliable and have even pressure loading that will allow small dispersion. The thru bore will give you an alignment of pump element that gives you an even bearing load. This little pump offers high pressure operation. With an addition of gear teeth it has diminished the flow pulsation and reduced the noise. A blend of PTFE bearings are changed due to the way it tackles heavy loads, low shaft speeds and maximum levels of contamination. The PTFE can take on high levels of contamination that want hurt the pump. The PTFE is also self lubricating it...

These are medium heavy duty motors. When pressure starts to ramp up during start up, the balance plate starts in and gives low internal leakage for the utmost starting torque. The roller stator is known to be apart of these motors makeup. This type of application uses the rollers for sealing certain points of the rotor assy. The motor has pressure ranges up to 4000 PSI and flow rate up to 25 GPM. It has eleven displacements that go from 7.4-45.6 cubic inches. They have quite of bit options on mounting flanges and output shafts. Also available are the bearing,...

If you need a medium heavy duty motor then this is the unit for your heavy duty fluid operations. These motors off a three zone, orbiting disk valve that include a spring biased face seal. This motor uses a Rollor Stator format. It uses rollers for significant sealing points of the rotor assy. By using this it will reduce leaking and not so much internal friction that the end result is higher mechanical and volumetric productivity for this motor. It uses viton shaft seals. Pressures range up to 4000 PSI and rates of flow up to 40GPM. It has eight...

This is a 30,000 Series single acting hydraulic cylinder. There are some key characteristics of this cylinder that are worth noting. The operating pressure go to 2000 psi. The plunger diameters go from 2: to 9.375″. It has lifting range to 138,2000 lbs. The pin eyed mountings are rather typical with trunionn types feasible for this unit. With every regular single acting telescopic cylinder that come from the factory with automated air bleeders, which gets rid of doing it manually. The seal and bearing cartridge are adjustable. Each of the outboard bearing rings and pliable sealing rings are telfon lubricated...

These pumps are almost the same as NSH systems, minus the unloading pressure signal is the full amount of the internal pressure. As well as it being the external pressure from an extra pumping system. The operation is most helpful in limiting the horsepower that is taken from the prime mover in numerous pump circuit systems. The combined flow range is up to 197 gpm. It has displacements up to 9.10 each section. The maximum pressure up to 2500 PSI. It has a maximum speed up to 2500 RPM. The rotation is A or C and it has journal bearings....