Oil Hydraulic Single & Multiple Pumps/Motors – SAE B & C 2/4 Bolt Shaft End Covers
Posted by Tammy Soper on
Oil Hydraulic Single & Multiple Pumps/Motors – SAE B & C 2/4 Bolt Shaft End Covers
Pressures to 2000 PSI/140 Bar
Output to 90 GPM/341 lpm
Motors up to 80 HP
Shaft End Covers Type 1
If you need to know the shaft rotation, look at the unit with shaft pointing in the your direction, and the idler gear under the shaft. When it is CW rotation, the flow will go left to right. The inlet port should be on the left and outlet on the opposite side. It will flow in the opposite way with CCW rotation. And the inlet and outlet will be in reverse of what the CW was … but not the direction of the rotation. (double bearing shaft end cover can be used with code 73)
Double outboard bearing of a shaft end cover is when a drive shaft is to one side or overhung load.
So the charts will show code selection for pumps and motors, single bearing, double bearing and rotations for each SAE B – C & for a 2 bolt – 4 bolt.
If you have any questions about this, call us at
800-361-0068
sales@hydrostatic-transmisison.com
