Denison Goldcup Series M46F & P46F Model D Shaft Assy
Posted by Tammy Soper on
Denison Goldcup Series M46F & P46F Model D Shaft Assy
You will need to put the snap ring (2c) on the shaft (1c) and make sure it is up against the shoulder.
Push the bearing assembly (3c) into the shaft following these instructions:
Use some force (do not beat in with a hammer)push the bearing cone assy. into the shaft. The bearing needs to be with the large end of taper on the shaft first.
Put in the outer race ((b) of the bearing into the cone assy.
Put the inner (c) and outer spacer rings (d) into the shaft.
Put the outer bearing race (e) into the shaft and center.
Push the bearing cone assembly (f) into the shaft, bearing needs to be put together with the small end of taper into the shaft first and make sure it up against inner spacer ring.
Thread a lockout nut (4c) into the shaft and make sure it is in place up against bearing assy.
If you need further help with this, please let us know.
800-361-0068
sales@hydrostatic-transmission.com
