News and Helpful Videos

Vickers Hydraulic PVE41-25V Piston Combination/Intergrated Pump This unit is a 72 or79 1/min (19 or 21) USgpm at 1800 r/min PVE piston pump and it is also a 25V fixed intra vane pump all in one unit with a single outlet and a double outlet ported. This can used in fixed and variable flow procedures.It will lower our costs because there is only one mounting pad and one inlet line for two independent pumps.You also can get a low noise model. These are usually for operating speeds for electric motors.These are considered inline variable displacement pumps. There are three different...

Vickers PVE Hydraulic Piston Pump Load Sensing Compensator CVP This unit provides all pressure types under any situation that leads to the maximum load. It instinctively knows to accommodate the pump flow feedback that goes to a remote pressure signal and keeps an outlet pressure at the right bars to adequate load pressure. the essential pressure limiter countermands the load sensing control, lowers the pump displacement as the pre-determined maximum function is reached. The 200 PSI is reached within 14 bars of the pressure settings you gauged for the compensator. If you need more info on this topic. Call us...

Denison P6V Hydraulic Pump General Characteristics Denison 6 & 7 Gold-cup axial piston pumps are above the grade for new ideas which give these pumps superior pumping and control innovations. Such as the rocker cam – it is used to control pump displacement that reduces wear, smaller size and better speed control response. the control vane actuator does away with the linkage and backlash characteristics in common stroking cylinder models. Standard controls for this series are: rotary servo compensator over ride additional option controls Listed befow on the chart you will see different characteristics of the Goldcup series: If further...

Sundstrand Sauer Danfoss Series 40 Hydraulic High Force MDC This affects M46 variable displacement pumps and tandem pumps. It has improved the control options on these pumps. The controls function to return to the neutral position by by lowering the potential of the control to bind and getting out of the neutral position. The control kit has either been altered or upgraded, so single components from the older modes are not interchangeable with the newer parts. The whole control is interchangeable. Parts within the kit will have updated part numbers. And all newer kits of course have the updated parts...

Vickers Hydraulic PVE Piston Pump – Adjustable Max Stop Control You will need to loosen the locknut on the adjusting rod. Next turn the adjust rod clockwise to lower the maximum pump or turn it counterclockwise to bring it to it’s highest level of pump efficiency. To make sure it stays at the desired setting, make sure to tighten up the locknut. To get it to prime, manually adjust the control setting by 40% for the highest level of flow. This will make this control will engage the maximum pump flow to be externally adjusted from 25% to 100% and...