News and Helpful Videos

This is a fixed displacement motor. The size of the frame is 10-180. It has a PSI of 5000. The parts list below is to help with ordering parts and to know the displacement of the motor. If you need to order parts go by the X in the column of the model number you want. Also you can take your unit to a hydraulic supplier and they can help with ordering parts or repairing your unit. Which is what we can do for you. We repair all models of Rexroth’s. So give us a call if you need help...

Rexroth A10V085 Open Circuit Hydraulic Pump Ports ANSI B92.1a-1996. 30 degrees pressure angle, flat base, flank centering, fit class 5 Ports ANSI B92.1a-1996. 30 degrees pressure angle, flat base, flank centering, fit class 5 Ports ANSI B92.1a-1996. 30 degrees pressure angle, flat base, flank centering, fit class 5 Ports ANSI B92.1a-1996. 30 degrees pressure angle, flat base, flank centering, fit class 5 If we can assist you further with repairing your Rexroth Unit, Give us a call at 800-361-0068 I sales@htsrepair.com

General parts breakdown :     If you need more info on these types of pumps, call us at 800-361-0068 sales@htsrepair.com

on Eaton Hydraulic Pump Series 33-76 C- Neutral zone has zero flow F- max that is allowed on control handle overstroke. The radial setting of control handle to shaft can vary @ 7-1/2 increments. Torque on this is 3-21 lb and it may have detent. Total torque is 150 k=lbs Look for the number on the orifice plate, the diameter will be in the thousands of an inch. Make sure when you put it in you can see the size and put in place. Plate orifice put in the control valve pressure override makes sure the speed of the displacement...

Place the cradle on a clean area. Place the rocker cam on the cradle and make marks so you know where your top assy goes. Put the oring around the spacer and put in the vane seal. Put in the check valve within the spacer and put together the two backup plates that have a v notch. Next put in the cartridge in the slots in cam and do the same on the other side. Put in four holddown vanes along with springs. The D & V models put in on the side of the control vanes. Place the control...