News and Helpful Videos

Some general information about this series of rotating groups.   Each series tells the parts and part numbers for the rotating groups. As each series numbers go higher, that means parts will no interchange with all model numbers (you can’t put parts from a 64 in a 33 series).   A (Spacer Height)- B (Shoe Flange + Retainer Plate) = C (Fixed Clearance .008 Max) Before you start, make surface is clean from debris and clean all parts with fluid. Dry them off with compressed air or lay them out to dry on their own. If any parts are damaged,...

Pressure Valves – Flushing and Boosting This valve is made to take out heat from out and around the circuit (closed) so there is only the lowest amount of charge pressure is existing. If pressure is not right then there will be flushing of the case. Take out the warm pressure fluid from the low pressure side that is in the motor case. Next it goes into the reservoir and leakage fluid. When the pressure fluid that is taken out of the circuit (closed) by this means, will need to have replaced with oil that is cooler and goes back...

on Racine PSV-40 Vane Pump Flange mounted and it is a RH rotation pump. It has a keyed shaft. The range from the mounting flange to the middle of the port is larger by 3/8″. Coupling system is wet model. The main pump doesn’t have a rear shaft seal. It does this so the adapter can fill up with fluid so the emollient greases and cools the coupling. On the (A) part the trailing pump on a SV-40,80,100 it has extra holes for mounting. On the unit opposite (A)when the weight goes above 65 lbs you have to use this...

on Parker/Denison T6DR – T6DRM Pumps T6DR Unit T6DRM We can help with all your Parker/Denison needs for hydraulic pumps and motors. Call us today 800-361-0068 sales@htsrepair.com

Gauge Pressure Ranges 8000 PSI, 68.9 bar A or B port 2. 200 PSI, 13.7 bar for case port 3. 500 PSI 35 for replenish port 4. 1000 PSI, 68.9 bar for servo port When you put in the pressure gauge, you will need to make sure the relaxed modulating pin is kept in the port. Don’t put gauge in servo filter line when isolation ring plug is put in when you don’t have a “T” fitting. If you do this you will have damage to your auxiliary shaft.       Replenish Circuit Isolation Plug If the isolation plug...