Vickers F3 25VQT Thru Drive Hydraulic Vane Pump

Posted by Tammy Soper on

Vickers F3 25VQT Thru Drive Hydraulic Vane Pump

Vickers recommends that if your want good performance out of your unit use a full flow filtration so that it meets expectation from ISO clean code, 16/13 or better. Use OFP, OFR and OFRS filters.

If you want the cartridge kits to go in the reverse , take out the 2 screws and reverse the spot of the inlet support plate and outlet support plate. Then put it back in, put back in the screws. Put on your pump cover to make sure everything is in alignment. Remove the cover and tighten up the screws.

And when you order parts, especially parts that are meant to be a right or left rotation, make sure you order right or left or it will not work.

All the diagrams, charts and model code breakdown how the units are assembled and if you have this model what it needs and doesn’t need. What model uses this instead of that.

But if you have further questions, call us at 800-361-0068

sales@hydrostatic-transmission.com

 

  


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.