Sundstrand Sauer Danfoss Series 40 M46 Displacement Limiters

Posted by Tammy Soper on

Sundstrand Sauer Danfoss Series 40 M46 Displacement Limiters

The units M46, PV and PT have mechanical displacement limiters that are in the servo covers (this comes as an option). The highest displacement setting can be set from 0 to any amount from its maximum displacement in either or direction. You can adjust the settings by rotating the limiter screws.
A full turn of the screw shows a change of about .24 inches. A full unit displacement is accomplished by the adjuster screw at it highest extension from the servo cover. When you get your pump from the factory the limiters are set at the maximum displacement. And anti tamper seal sleeves are issued also.
All limiters may not be suited for every operation, consult manual or call the dealer.

If you need further questions concerning this subject, please let us know.
800-361-0068
sales@hydrostatic-transmission.com


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.