Sundstrand Sauer Danfoss Output Flow Direction vs EDC Signal Input
Posted by Tammy Soper on
Sundstrand Sauer Danfoss Output Flow Direction vs EDC Signal Input
A1 = EDC connector pin A for variable pump or tandem front pump
B1 = EDC connector pin B for variable pump or tandem front pump
A2 = EDC connector pin A for tandem rear pump
B2 = EDC connector pin B for tandem rear pump
Dual Coil – this control uses two command sources, it the results of them both signaling. It can operate from the ground or where the operator is sitting.
MS Connector – gives a mechanical, threaded retention between two connector halves. Alot of military procedures require this.
Intrinsically Safe – this will limit electrical energy to levels below the ignition point of flammable gases.
If you need more info on this topic, let us know. 800-361-0068
sales@hydrostatic-transmission.com
