Sundstrand 90 Series Hydraulic – Mounting Flange Changes

Posted by Tammy Soper on

The B Pad auxiliary mounting flange has been changed on these models: 42, 130, 180 and 250cc. All the pumps will be changed to a new arrangement.

The older units used a large cross section o ring. The groove in the flange will have a larger o ring in it (.103″) versus what it did have (.070″). The new o ring on the B Pad seal is like a donut style with a flat cover.

All the old ones will not use the small o ring and stepped cover plate any more. So make sure you throw the old one away and use the new style. If you have a model that is not listed but similar to the new style B Pad and cover, you can use it on your unit. New part number is 9004104-1540 oring.

If you need more info on these types of B Pads on Mounting Flanges, give us call at 800-361-0068

sales@htsrepair.com

Chart below shows the old part numbers and the new part numbers you will need to use in the future for replacing o rings, pad seal, flange cover and flange adapter.


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.