Eaton Charge Pump A & B Pad

Posted by Tammy Soper on

Eaton Charge Pump A & B Pad
Charge Pump parts
Tells about the internal/external discharge ports and remote filter ports
Standard, A Pad and B Pad Displacements ** Is the size, length & width of the parts. Nominal Dimension affects the charge pump by the displacement. Millimeters is how they describing the
length or width of the parts listed. *** The pan head mounting bolt on the b pad only, you need to seal the washer ( a must)
Displacements for the Pads
The kits for each pad includes four bolts, two dowels and a gasket. If you (3x’s) after charge pump & sub assy that means the pressure setting of the relief valve. You will need to multiply the three digit number by ten so you will know the pressure setting PSI.
*Wet B Pad Cover for Pressure Side Filter #108527-000

If we can assist you with charge pumps for your units or repair them,

Reach out to us at 800-361-0068 I sales@htsrepair.com


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.