Denison Goldcup Series M6H/M7H Model C & A Mounting Port Block Assy
Posted by Tammy Soper on
Denison Goldcup Series M6H/M7H Model C & A Mounting Port Block Assy
This will have a parts list and diagram breakdown.
You will need to thread the socket pipe plugs (2) into the port block.
Put in the oring (4) in the hollow hex plug (3) & thread it into the tapped hole in the top of the port block.
Next put in the gasket (8) in the housing assy (9).
Put in the two port plates pins (6) in the front of the port block assy. You will need to grease it will lubricant to the port plate (7) & to make sure the port plate is over the pins (6) on the port block.
Install the port block assy & port plate is over the end of the auxiliary shaft. Make sure that tubes 2,3 and 4 are right up against the port plate (7) is on the pins (5).
Put the 4 blots (5) and tighten it up to 150 ft lbs of torque.
Call us if you need any additional help with this. 800-361-0068
sales@hydrostatic-transmission.com
