News and Helpful Videos

Rexroth Rectangular & Square Head/Cap Flange Mounts The flange mount is the strongest and stable of the mounts. It will allow for long strokes to be done while the end that is on the other side to be support well without it sagging or binding the cylinder.Below are charts that show rod diameter, bore size and maximum pressure, along with other information.If you need further assistance with this call us at 800-361-0068sales@hydrostatic-transmission.com

Sundstrand Sauer Danfoss Series 40 – Controls On models M23 and M35 the pumps have a direct displacement control DDC system.The M46 pumps have a servo control with a either a manual displacement control MDC, a HDC hydraulic displacement control or a EDC electrical displacement control.Which ever one you choose it gives a positive smooth control of the transmission in either direction.Read in the charts.If you need more info on this, call us at 800-361-0068sales@hydrostatic-transmission.com

Vickers PVD80C Piston Pump Part 1 Controls mounted on pump for L.H. (CCW) shaft rotation rotate 180 degrees. for R.H. rotationBelow is a chart that tells about the rotation, charge pump, etc. And a diagram that explains about all the parts.If you need questions answer about this unit, call us at 800-361-0068Also you may send your questions to our email: sales@hydrostatic-transmission.com href=”https://blog.hydrostaticpumprepair.com/wp-content/uploads/2017/12/vickers-pvd80-piston-pump.jpg”>

Sundstrand Sauer Danfoss Series 40 – Design Features The chart will show design features of the Series 40 pumps and motors.It will help you with the shaft style, controls and auxiliary mounting pads. The charge pump and gives dimensional measurements.And if you need additional information, we are here to help with that.We can service your unit by repairing or rebuilding it. We can get parts for your unit. We specialize in all Sundstrand units.You can call or email us:800-361-0068sales@hydrostatic-transmission.com

Rexroth Tie Rod Mounts When your talking about flange mounts and tie rod mounts are about the same, except the tie rod are extended and they are used to mount the cylinder. So that you don’t have sagging or putting your cylinder in a bind when you have long strokes. The free end of the cylinder needs to be supported for the thrust load procedures, blind or cap end tie rod extensions are best. If you have a tension load procedures, rod or head end tie rod ext. are better. Tied rod mounts are meant for many different procedures, but...